Safety in Using a Wood Heater

Safety in Using a Wood Heater


This is what ought to be done to safely work with a wood heating system. Before you ever start a fire in your wood heater check the stove pipe and chimney. Turn to see they are properly connected and they haven't any holes showing. Fumes like carbon monoxide, as well as smoke, could escape into your house by way of a hole in the stove pipe, as could flames f you ever have a small chimney fire. That could start a house fire.

Open a window some to allow oxygen from outside to enter the room where your heater is burning. The fire burns up the oxygen within the room when the heater is operating.

It is a good idea to have your heater sitting on a sheet metal base, that stretches out in front of the heater's door. This metal sheet spreads out any excessive heat on to the floor and should the fire spit out burning embers once the door is opened for putting wood in, the ground will be protected from burns. This can often happen if the wood being burnt is not completely dry. Some types of wood like spruce will tend to pop and spit embers frequently while burning.

Check the fire proof chord seal round the door of the heater, ensuring you can find no holes or gaps present. You need the fire box of one's heater air tight when you close the draft lever shutting off the ventilation. The draft lever allows you to control how hot the fire burns. Closing the draft lever decreases the fire by stopping its oxygen supply.

You need to keep a door seal repair kit readily available. It includes a tube of liquid adhesive and a length of fire proof rope-like chord. If you can start to see the light of the fire through the edge of the entranceway where the door seal is located, repair is needed.

It is advisable to do the repair when the door of the heater continues to be quite warm. Measure and slice the correct length of door sealing chord that may fit all over the door in the groove. Scrape out the old chord still inside the heater door groove so when clean wipe it with a rag. Apply the liquid adhesive a few drops at the same time to the inside of the groove. The heat of the door may cause it to become sticky in a few minutes. When the adhesive becomes gel-like, press the chord into the groove with a screwdriver. Contain the chord in place for some moments although it sets, attaching several inches of the chord to the groove at a time. When it's all in place, close the heater door. Tighten the entranceway latch whenever you can and allow it set for about quarter-hour.

The chimney should be checked for an excess of soot deposited on its inside. This can be a good idea to open the hole for the soot to fall down the chimney and stove pipe into the heaters burning chamber. That is done by turning two fire bricks on their side near the top of the heaters burning chamber.

Wear old clothes. Take hand wiping rag, chimney cleaning brush, and the tools needed to remove the stove pipe cap near the top of your chimney. Carefully climb onto the roof. Remove the chimney cap and brush the soot off the within of the cap. Look in the chimney. You'll likely visit a layer of black soot covering the the surface of the chimney. Blow it away. Take the chimney brush and carefully push it down and pull it up the chimney. Do that repeatedly and soon you see no more black near the the surface of the chimney. When it's clean reattach the cap onto the chimney, clean the hands and tools with the rag and become careful climbing down off the roof. Invest  Wood heater melbourne . It is not worth getting hurt by falling.

Wood heat is a comfortable method of heating your home but it does take some safety knowledge and precautions to do so safely.